Please do not return this product to the store, Troubleshooting – Bissell 25A3 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
DirtLifter PowerBrush does not turn
Possible cause
1. The brush belt or pump belt Is off or broken.
Cleaner not picking up solution
Possible cause
1. ReadyTools dial may be on the
wrong setting for the cleaning Job.
2. Poor tool position.
(Hand held attachments only).
3. Removable nozzle may not be properly attached.
4. 2-in-1 tank lid is not properly installed.
5. 2-in-1 tank is not properly seated.
6
.
2-in-1 tank has picked up maximum dirty water.
7. The lint screen may be clogged.
Remedies
1. Refer to Remedy 4 on page 16 to check if
brush belt or pump belt is broken.
Remedies
1. Set ReadyTools dial to either floor
cleaning or tools.
2. Adjust angle; apply more
downward pressure.
3. Make sure nozzle is on correctly by
slightly raising front of machine to line up
slots on the base of the machine with the
hooks on nozzle. Attach at base first and
then click nozzle into place. Refer to
image 5 on page 12.
4. Re-install lid; refer to the images on page 10.
5. 2-in-1 tank must be fitmly seated to function;
remove and reseat 2-in-1 tank.
6
.
Empty 2-in-1 tank and refill, refer to the
Operation section.
7. Clean out lint screen. Refer to page 12.
Other maintenance or service not inciuded in the manuai shouid be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store
F=or any questions or concerns, BISSELL is happy to be of service.
Contact us directly at 1-800-237-7691.
8 0 0 . 2 3 7 . 7 6 9 1
17
ug120-4078_25A3_908.indd 17
10/14/08 1:21:09 PM