Workrite Sierra HX Crank Assembly Instructions for 3-Leg Front-Crank models User Manual
Page 7
Workrite Ergonomics | 800.959.9675 www.workriteergo.com
7
Workrite Sierra HX™ 3-Leg Crank Workcenters - Assembly Instructions
a
b
Attach Side Legs to Hex Shafts and Crank Tubes
Use remaining Deep Hex Shaft (L) to connect Right Leg to Crank Tube (D), inserting short end of
shaft into leg and long end into Crank Tube.
Use remaining Shallow Hex Shaft (K) to connect Left Leg to Crank Tube (D), inserting short end of
shaft into leg and long end into Crank Tube.
Base-only models, skip to step 9.
7
Right Leg
L
D
Left Leg
K
D
b
8
Attach Side Legs to Table
Position leg assembly to align mounting holes to pre-drilled holes in Top (A) - it might be
necessary to adjust braces - then attach loosely using Pan Head Screws (M). If you use an electric
screwdriver, be sure it is on the lowest torque setting to avoid stripping the threads.
a
M
A
3 screws per
Short Brace
C
6-10 screws
per Long Brace
B
4 screws per
Medium Brace
F