Workrite Sierra HX Crank Assembly Instructions for 3-Leg Front-Crank models - Manual (Page 5)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 5
Workrite Sierra HX™ 3-Leg Crank Workcenters - Assembly Instructions
5
Attach Medium Braces to Side Legs
Attach one Medium Brace (E) to end of each Side Leg using Button Head Screws (J). If you have
a 24” deep or less worksurface, use the holes towards the back of the brace so that the brace
extends out above the long part of the foot. For deeper worksurfaces, use the center holes of the
brace so that it is centered on the leg. Do not tighten screws completely - allow them to slide
left and right in brace.
a
worksurface 24" deep or less worksurface more than 24" deep
right leg
left leg
E
J
right leg
left leg
a
6
Attach Center Leg to Hex Shafts, Crank Tubes and Table
Lay out the leg assemblies, 2 Hex Shafts (1 K and 1 L), and Crank Tubes (D) in the proper location. a
a
Left Leg Right Leg
D L
K