Wine Guardian Ducted Split Wine Cellar Cooling Systems (SS200) - Manual (Page 61)

56
Troubleshooting
WARNING
BEFORE PROCEEDING, READ AND UNDERSTAND THE SAFETY INFORMATION CONTAINED IN
THE SAFETY SECTION OF THE WINE GUARDIAN MANUAL.
Typical start up problems
Possible Cause
Loose, improper or defective remote interface
controller or humidistat cable
Solution
Check power, and remote interface
controller or humidistat cable
Incorrect remote interface controller or
humidistat (optional) settings Check the remote interface controller and
optional humidistat setup for the application
Changed settings on the remote interface
controller A common problem is not waiting long
enough for the internal timers to complete
their timed delay
Unit does not start up
Power Switch Light is Off
Possible Cause Solution
Switch not on Turn on switch
No power to outlet Check circuit breaker and wiring
Unit not plugged in Plug in the unit
Power switch light is on and the remote interface controller light is off
Possible Cause Solution
No power to remote interface controller Check main control board for L.E.D.
indication
Check wiring for loose, broken or frayed
connections
Check wiring for proper splicing
Remote interface controller may be faulty
Remote Interface Controller may be faulty
Power switch light is on and the remote interface controller light is on
Possible Cause Solution
Remote interface controller is not set up Check remote interface controller set up in the
properly guide
Press fan ON switch to check evaporator
fan only
IMPORTANT
This section is intended as a diagnostic aid only. For detailed repair or parts replacement
procedures, contact a qualified service company. Check the following table for some
solutions before calling a service technician .