Changing a fuse, Adjusting the drag control dials – Vinten Radamec Fusion FHR-100 User Manual
Page 40

Fusion FH-100 and FHR-100 pan and tilt heads
38
Changing a fuse
1.
Switch OFF power to the head [18].
2.
Carefully insert a small, blunt screwdriver or similar tool into the side of the fuse
compartment and lever out.
3.
Lift out the fuse compartment [17] (Fig. 20).
4.
Replace the failed fuse, then replace the fuse compartment, pushing it firmly into place.
5.
Switch ON power to the head.
Adjusting the drag control dials
The pan and tilt drag control dials ([4], [21]) may require adjustment after prolonged use. These
adjustments must be carried out by competent personnel only. Contact Vinten Radamec for
servicing of the FH-100/FHR-100 pan and tilt heads.
Fig. 20 Fuse compartment
This manual is related to the following products: