Vintage Cellars Active Humidity WhisperKOOL - Manual (Page 4)

Page 4 | 1-800-343-9463
AH 072313
Removing the Cover
1. Move both slide controls to the bottom position.
2. Use a screwdriver to loosen the screws at the bottom of the humidistat as shown in Figure 5.
Removing the Cover
1. Plug the circular connector from the humidistat cable into the circular connector on the unit as shown in
Figure 4.
2. Route the wire from the unit to the desired humidistat location.
Mounting Without a Wall Mount Plate
1. Make sure the power to humidistat electrical wires is shut off at the main electrical box before installing the unit.
2. Position the back half of the humidistat cabinet on the wall or junction box and ensure it is level and covers the
junction box completely.
3. Pull the electrical wires through the hole at the terminal block of the humidistat.
4. Drill holes in the wall through the 2 mounting holes in the back of the humidistat cabinet as shown in Figure 7
and insert anchors into the holes.
5. Fasten the humidistat to the wall with screws through the mounting holes.
Figure 5
Figure 7
Figure 8
Slide controls
Figure 6
3. Remove the top cover carefully forward and then upward to
loosen the top lock. See Figure 6.
HUMIDISTAT INSTALLATION
Screws
Wall anchors
Terminal Block
Wall mount plate
Figure 4