Vetter Ultra Flat Bags STec 10 bar (145 psi) - Manual (Page 9)

Page 8/15
Never position 3 or more bags on top of each
other!
Ensure load against slippage.
In order to fully use the strengths of the Ultra Flat Bag S.Tec, the
distance between load and bag should be at a minimum.
The foundation support must brace at
least the complete area of the bag and the
smallest edge length of the foundation
support must be larger than the height of
the foundation support. Metal must
never be place on metal!
Attention: danger of slipping!
With slippery ground (ice, snow, mud etc.) place anti-slip materials
under the bag in order to increase adhesion. Point-shaped loads
are to be avoided, e.g. construction claws or screws. Never place
the bags on sharp edges, hot or red hot components. Use suitable
temporary storages and cover the complete contact area of the
bag. Protect the bag against flying sparks during welding or se-
paration work. Do not additionally load bags with such things as
hydraulic lifting devices, winches or falling loads.
Never remain beneath a lifted load, never hold
the load from below!
Remain at a distance!
Avoid shearing effects by squeezing of the bag when lowering the
load!
During operation never stand in front of
the bag but always to one side, because the
bag could catapult outwards under
unfavourable conditions!
The lifting sequence is to be stopped
immediately if there is a function failure!
An Ultra Flat Bag S.Tec can burst under adverse conditions with
incorrect operation, incorrect handling or by manipulation on the
controller and/or inflation hose (problems concerning pressure
waves and sound waves, uncontrolled movement)!
Vetter Ultra Flat Bags S.Tec are not suited for
use in explosion endangered zones!
Special versions are possible on request!