Vetter Ultra Flat Bags STec 10 bar (145 psi) - Manual (Page 6)

Vetter Ultra Flat Bags S.Tec 10 bar
Page 5/15
2.2 Vetter safety coupling system
a. Input coupling of the controller
Connect the air supply hose or the connection hose of the pres-
sure regulator to the nipple of the input coupling (1) on the cont-
roller pushing the nipple solidly into the coupling until the ratchet
action can be felt. In order to ensure that it is correctly connected:
turn the brass sleeve (2) of the coupling opposite to the safety
pin (3).
b. Inflation hoses
To connect the inflation hoses to the corresponding controller or
to the Ultra Flat Bags S.Tec, press the hoses or bag nipple solidly
into the coupling until the ratchet action can be felt. The coupling
sleeve must be seated on the support ring without any gap (1). To
release the connection (only in the pressure-free condition) the
nipple must be solidly pressed against the spring pressure in the
coupling. At the same time the coupling sleeve must be pushed
back. The coupling then releases.
c. Inflation with an 8 bar inflation device
The Ultra Flat Bags S.Tec safety coupling system cannot be used
for inflation with other inflation devices. However, should it be
necessary, in exceptional cases, to inflate with the Vetter 8 bar sys-
tem then the 10 bar / 8 bar adapter must be used.
2.3 Product description
Vetter Ultra Flat Bags S.Tec are made by hand from high quality
raw materials so that after completion, a seamless bag is produ-
ced. The semi-finished product is vulcanized under the influence
of pressure and temperature and by doing this the individual lay-
ers bond to form an elastomer body. After production has been
finalized, each Ultra Flat Bag S.Tec is subjected to a plant accep-
tance test within the scope of quality assurance.
Material of the Ultra Flat Bags S.Tec : CR/Aramide, hot vulca-
nized
1
2
3
1