beautypg.com

Front height speakers, Subwoofer(s), Speaker distance – Universal Remote Control (URS) DMS-AV TSP20007.10.14 User Manual

Page 33

background image

Page 34

Front Height Speakers

It is not necessary to have front height speakers. Set the Front Height
Option in the on-screen display to Yes or No, or set this in the URC
Accelerator, based on the surround channels availability. If set to none, the
front height speaker information will be reproduced in the front speakers
and although no information is lost, the sense of sounds coming from
directly above you may be lost. If front height speakers are used, surround
back speakers are not available.

Subwoofer(s)

There are four choices for subwoofer. If set to No, all bass information,
including LFE (.1 channel) will be routed to any speakers that are
configured to pass low frequency information, as described in the setup
above. If the individual speaker crossovers are not set to pass low frequency
information, and no subwoofers are used in the system, the low frequency
information shall be lost.

The most common setting for subwoofer is Preout 1/2, which allows for
connections of two subwoofers, taking advantage of the DMS-AV’s ability to
reproduce low frequency information through two subwoofers (.2).

Setting the Subwoofer to Preout 1 shall configure the DMS-AV to send low
frequency information from its Sub 1 preamplifier output only.

Setting the Subwoofer to Preout 2 shall configure the DMS-AV to send low
frequency information from its Sub 2 preamplifier output only.

Speaker Distance

Ideally the speakers should be positioned at an equal distance from the
listening position. However, physical limitations usually require placing the
speakers in other than optimum locations. The DMS-AV contains a means
to electronically move each speaker’s location. This allows for superior
reproduction of the directional cues available during movie or music
playback. Measure the distance in feet from your listening position to each
speaker. Enter this information into DMS-AV’s on-screen display, or into the
URC Accelerator Application. Default measurement units are feet, but units
may be changed to meters if preferred.

DMS-AV H

OME

T

HEATER

A

MPLIFIER