Universal Remote Control (URS) THZ-100 - Manual (Page 32)

Page 28
THZ-100 T
HERMOSTAT
How To Set The Cooling 2nd Stage Offset
If you desire to change the cooling 2nd stage Offset temperature
then use the arrow keys to move the highlight bar to Cooling (2nd
Stage Offset). If you do not have a multi-stage cooling system then
the Cooling (2nd Stage Offset) feature is not displayed in the menu
list.
Press the key below the OK key label in the smart-key label at the
bottom right of the display to select this option. If you decide to
cancel the operation then press the key below the Cancel key label
in the smart-key label at the bottom left of the display.
After pressing OK the screen updates to a screen that says Cooling
2nd Stage Offset at the top of the screen and the current offset
temperature in the center of the screen. Use the arrow keys to
adjust the temperature up or down to the value you desire.
Press the key below the Set Temp key label in the smart-key label at
the bottom right of the display to save your new offset value. If you
decide to cancel the operation then press the key below the Cancel
key label in the smart-key label at the bottom left of the display.
The initial value is setup when the thermostat is initially setup
through the MRX Advanced Network System Controller. The default
value is 50F or 2.50C.