Universal Remote Control (URS) THZ-100 - Manual (Page 20)

Page 16
THZ-100 T
HERMOSTAT
Selecting Hold for Time
If you desire to hold a particular desired temperature for a specific
period of time, use the arrow keys to move the highlight bar to Hold
for Time.
Press the key below the OK key label in the smart-key label at the bottom
right of the display to select this new mode. If you decide to cancel the
operation then press the key below the Go Back key label in the smart-key
label at the bottom left of the display.
If you select Hold for Time, the screen updates to the Set Hold-To Time
display with the current time displayed. Use the Up or Down arrows to set
the time period that you want to hold the desired temperature. The Up
and Down arrows changes the time in 30 minute increments. The maximum
hold time is 24 hours.
When you have selected the desired time press the key below the Enter
key label in the smart-key label at the bottom right of the display to select
this new mode. If you decide to cancel the operation then press the key
below the Cancel key label in the smart-key label at the bottom left of the
display.
Alternately, if you let the programs screen time out with Hold for Time
highlighted, by the highlight bar, the hold mode is selected and the screen
updates to the Set Hold-To Time display.
On the main screen Hold to with the desired hold to time is displayed
above the current temperature information.