Universal Remote Control (URS) TRC-1280 - Manual (Page 6)

TRC-1280 T
OUCH
S
CREEN
Connecting the Battery Pack
Unlock the rear cover by pressing down on the spring lock at the
top of the cover. Remove the cover. For shipment from the factory,
the battery is left out of the TRC-1280. Place the battery into the
battery compartment, making sure you align the contacts on the
battery to the contacts on the TRC-1280. The battery will snap into
place when aligned properly. Replace the cover and snap it into
place.
Using the Charging Base
Plug the 6V DC adapter into a power outlet
and into the back of the charging base.
Gently place the TRC-1280 into the cradle
of the charging base. It automatically aligns
itself to the contacts on the charging base.
The Status light should immediately light.
Red indicates that it is charging. Blue shows
that it is fully charged. There is no harm in
leaving the TRC-1280 on its charging base
whenever it is not in use.
Two-Way via Wi-Fi
To use the TRC-1280 with any two-way companion product, the
TRC-1280 must be configured by your installer to be part of a LAN
(local area network) via a Wi-Fi b/g access point or router. This is not
user configurable. If you have any questions, consult your custom installer.
Page 3
Red indicates charging, Blue
that the remote is fully charged.