Universal Remote Control (URS) SR3 - Manual (Page 27)

Transport Control Punch Through
This “punch through” enables you to set up
your remote so that the DVD Transport
Controls (PLAY, STOP, FF, REW, PAUSE, SKIP
and RECORD) will also operate in other
component modes on the remote control.
STEP 1: Press and hold the component
button you want to add Transport Control to,
such as [CABLE/SAT] or [TV], and the SELECT
[SEL] button at the same time for two seconds
until the Component LED light turns on.
STEP 2: Press the [PLAY] button. The component
LED light will blink once.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode, and you
will have to start over with step one.
STEP 3: Press the [DVD] button that you want
to use as the source of Transport Control. The
component light will blink two times to confirm
it is saved.
Transport controls
Page | 26
SELECT
PLAY
COMPONENT
BUTTONS