Universal Remote Control (URS) SR3 - Manual (Page 30)

Page | 29
Erasing All Learned Commands
from One Component
This function allows you to erase all the learned
commands from one component.
For example, if you want to erase all learned
commands on the TV component button
because you bought a new TV, the process is
very simple.
STEP 1: Press the component button where all
the learned commands are stored and the
[ENTER] button at the same time for two seconds
until the component light turns on.
STEP 2: Press and hold both the component
button you want to erase and the [PAUSE]
button at the same time for two seconds, until
the component LED light blinks twice to confirm
the erasure.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode, and
you will have to start over with step one.
STEP 3: To exit Erase mode, press and hold
both the component button and the [ENTER]
button at the same time until the component
LED light blinks three times.
ENTER
PAUSE
COMPONENT
BUTTONS