beautypg.com

Learning method – Universal Remote Control (URS) MX-350 User Manual

Page 6

background image

9

8

Note: If a component fails to turn off after you have entered all of the code
numbers listed for your brand, you can scan through the other brands in the
table using the UP and DOWN buttons (there is a chance that your
component was actually manufactured by another brand). However, most of
the code tables are so large it is usually faster to use the Learning Method on
Page 9.

When the component turns off, save the code number you entered
by pressing the SAVE button that appears on the screen.

Exit SETUP mode by pressing the MAIN button two times. When
the display shows “MAIN”, you are back in normal operating
mode.

Repeat steps one through nine for each of your devices. If you are
missing any commands, use the learning method, described next

Learning Method

The MX-350 can learn commands from your old remote controls one-but-
ton-at-a-time by following these simple steps:

Line-up the MX-350 with your old remote control, head-to-head,
one or two inches apart.

On the MX-350, press and hold the MAIN and ENT (Enter) buttons at
the same time for approximately three seconds. The top of the dis-
play will show “SETUP”. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the MX-350 will time out and return to
normal operation.

Press the LEARN button.

The top of the screen will change to “LEARN”.

SAVE

Button

Code

Number

You

Entered

MAIN

Button

T h e M X - 3 5 0

8

9

Scan Up to the next Code
Number

Scan Down to the previous
Code Number

Press Power On or Power
Off to test if the device
powers off.

10

U n i v e r s a l R e m o t e C o n t r o l , I n c .

LEARN

Button

1

2

3