Universal Remote Control (URS) TRG-200 - Manual (Page 7)

Page 4
TRG-200 U
MOTION
R
EMOTE
Installing the Batteries
Open the battery cover by pushing up on the spring
lock at the bottom of the cover. Remove the cover.
Observe the + and – polarity indicators inside the bat-
tery compartment and the batteries. Place two AA bat-
teries into their positions inside the battery compartment.
Now, replace the battery cover and snap it into place.
Main: Displays the MRX-20’s Main menu via a connected display device.
l When a display device is OFF: Pressing Main sends out a
series of commands to turn ON all required devices to view
the on-screen interface.
l When a display device is ON: Pressing Main, while the
display device is on, opens the Main menu of the MRX-20.
Umotion: Allows for motion control and button selection via
on-screen interface. While viewing a device, press the Umotion button
to activate on-screen control and open the Quick Bar menu. Point the
TRG-200 towards the television. As you move the remote, an
on-screen pointer will mimic your movements. To select a button,
hover over your selection and press the Umotion button again.
Pressing any button other than Umotion, exits the on-screen interface
and motion control.
Note: Using an Internet TV? Keep in mind, the on-screen interface
only works with devices connected to the MRX-20 Advanced Network
System Controller. If you are using the display device’s internal
sources, like Internet TV (Netflix, Hulu) or a directly connected device,
they will not operate with Umotion.