Reader configuration parameters, Reader, Reader/baudrate – ThingMagic Mercury API v1.23.0 User Manual
Page 65: Reader 65, Configuration parameters, This can avoid attempts using the wrong baud, Reader configuration, Parameters, Under, Parameters can be found in the
Configuring Readers
Level 2 API
65
Future firmware upgrades will support saving other configuration values.
To Save a configuration, simple set the parameters as desired then set the
parameter to a
SerialReader.UserConfigOp with the appropriate
parameter.
Codelets\SavedConfig for an example of saving and restoring
configurations on the M6e.
Reader Configuration Parameters
The following are all the available parameters broken down by grouping:
/reader
/reader/baudRate
Type: integer
Default value: 115200
Writable: yes
Products: M5e (and derived products), M6e
This parameter (present on serial readers only) controls the speed that the API uses to
communicate with the reader once communication has been established. When a
Reader.Connect() occurs the serial baud rate is “auto-detected” by attempting supported
baud rates in the following order:
1. value of /reader/baudRate
2. 9600
3. 115200
4. 921600
5. remaining supported baud rates in increasing order
Once connected if the connection baud rate is not the same as the value of /reader/
baudRate the module’s baudrate will be changed to /reader/baudRate.