Included components, Additional required equipment – ThingMagic Vega User Manual
Page 7
Included Components
ThingMagic Vega Set Up Guide
7
Included Components
With the Vega RS, you will receive the following components:
The ThingMagic Vega reader
One, Two or Three antennas and Cables, depending on your configuration
Documentation and software development kit packages can be found at
http://rfid.thingmagic.com/devkit
One Jumper Terminator for the
on the GPIO Connector. (
Not included
with the IVR
)
Note:
If the ReaderEnable jumper is not connected another method must be used to “turn on”
the reader as described in
Additional required equipment:
Straight-thru DB9 serial cable.
USB to Serial adapter (if the connected PC doesn’t have an RS232 COM port)
One DC power supply with power cord (
Optional
)
Note:
This product is intended to be supplied by a Listed power supply marked ‘LPS’ or ‘NEC
Class 2’ and rated 8-16V, minimum 1A.
W A R N I N G !
The Vega antenna ports may be susceptible to damage from Electrostatic
Discharge (ESD). Equipment failure can result if the antenna or communication
ports are subjected to ESD. Standard ESD precautions should be taken during
installation and operation to avoid static discharge when handling or making
connections to the Vega reader antenna or communication ports. Environmental
analysis should also be performed to ensure static is not building up on and
around the antennas, possibly causing discharges during operation. See the
M5e-Family Developer’s Guide | Appendix E or contact
[email protected] for more details on ESD.