Tjernlund P Series High Pressure Duct Boosters 8504064 Rev 05/98 - Manual

TJERNLUND PRODUCTS, INC.
1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE (651) 426-2993 • (800) 255-4208 • FAX (651) 426-9547
Visit our web site • www.tjernlund.com
P/N 8504064 ©1998, Tjernlund Products, Inc. REV. 5/98
TJERNLUND LIMITED ONE YEAR WARRANTY
Tjernlund Products, Inc. warrants to the original purchaser of this product that the product will be free from defects due to faulty material or workmanship
for a period of (1) year from the date of original purchase or delivery to the original purchaser, whichever is earlier. Remedies under this warranty are
limited to repairing or replacing, at our option, any product which shall, within the above stated warranty period, be returned to Tjernlund Products, Inc. at
the address listed below, postage prepaid. THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF,
AND TJERNLUND PRODUCTS, INC. EXPRESSLY DISCLAIMS LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM
THE USE OF THIS PRODUCT. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES AND NO AGENT IS AUTHORIZED TO
ASSUME FOR US ANY LIABILITY ADDITIONAL TO THOSE SET FORTH IN THIS LIMITED WARRANTY. IMPLIED WARRANTIES ARE LIMITED TO
THE STATED DURATION OF THIS LIMITED WARRANTY.
Some states do not allow limitation on how long an implied warranty lasts, so that limitation may may not apply to you. In addition, some states do not
allow the exclusion or limitation of incidental or consequential damages, so that above limitation or exclusion may not apply to you. This warranty gives
you specific legal rights and you may also have other rights which may vary from state to state. Send all inquiries regarding warranty work to Tjernlund
Products, Inc. 1601 9th Street, White Bear Lake, MN 55110-6794. Phone (651) 426-2993 • (800) 255-4208 • Fax (651) 426-4957.
HIGH PRESSURE DUCT BOOSTER ® EXHAUST FANS
M & P SERIES INSTALLATION AND MAINTENANCE INSTRUCTIONS
Please Read And Save These Instructions
Do not connect power supply until the fan is completely installed. Make sure that the circuit
serving the fan is switched “OFF” or that the fuse is removed.
This in-line fan may be mounted at any angle from horizontal to vertical.
1. This unit has rotating parts. Safety precautions should be exercised during installation, operation and
maintenance.
2. WARNING: Do not use these fans in hazardous environments where the fan’s electrical system could
provide ignition to combustible or flammable materials.
3. Turn centrifugal impeller by hand to make sure it rotates freely. If the impeller hits the housing, check the
screws securing the motor bracket. Adjustments can be made by loosening these screws. Tighten all screws
before operating fan.
4. If unit is used in a dryer application it must be periodically inspected. DISCONNECT POWER SUPPLY,
remove from mounting bracket and remove any lint build up from the impeller, through opening.
5. Ducted fans must always be vented to the outdoors.
6. Install fan at least (5) feet above the floor.
7. CAUTION: “For General Ventilation Use Only. Do Not Use To Exhaust Hazardous Or Explosive Materials
And Vapors.”
All wiring must be in accordance with local ordinances and the N.E.C.
WARNING: Check voltage of the supply circuit and verify that it corresponds with motor name plate.
GUARDS MUST BE INSTALLED WHEN THE FAN IS WITHIN REACH OF PERSONNEL OR WITHIN SEVEN
(7) FEET OF WORKING LEVEL OR WHEN DEEMED ADVISABLE FOR SAFETY.