Clarion DXZ466MP - Manual (Page 12)

12
English
DXZ466MP
Note: Be sure to read this chapter referring to the front diagrams of
chapter “2. CONTROLS” on page 3.
8. OPERATIONS
CAUTION !
Basic Operations
Be sure to lower the volume before switching
off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden loud
volume may hurt your hearing and damage
the unit.
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the carʼs
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
2. The illumination and display on the unit
light up. The unit automatically remem-
bers its last operation mode and will au-
tomatically switch to display that mode.
3. Press and hold the [SRC] button for 1 second
or longer to turn off the power for the unit.
Note:
• System check
The first time this unit is turned on after the wire
connections are completed, it must be checked
what equipment is connected. When the power is
turned on, the “SYSTEM CHECK” appears in the
display, then the unit returns to the clock display
mode. The system check starts within the unit.
When the system check is complete, press the
[SRC] button again.
Selecting a mode
1. Press the [SRC] button to change the operation
mode.
2. Each time you press the [ SRC] button, the op-
eration mode changes in the following order:
Radio mode CD/MP3/WMA mode CD
changer mode DVD changer mode TV
mode AUX mode Radio mode...
∗ External equipment not connected with CeNET
is not displayed.
Note:
• If the CD mode is selected when no disc is inserted,
the display shows “NO DISC”.
Switching the display
Press the [D] button to select the desired display.
Each time you press the [
D] button, the display
switches in the following order:
∗ In the case of a user title, only the top level is
displayed.
∗ In the case of radio/TV/AUX/DVD changer, the
display cannot be switched to “Title Display”.
∗ Once selected, the preferred display becomes the
display default. When a function adjustment such
as volume is made, the screen will momentarily
switch to that functionʼs display, then revert back
to the preferred display several seconds after the
adjustment.
∗ If the button operation is performed with the screen
saver function on, the operation display corre-
sponding to the button operation is shown for about
30 seconds and the display returns to the screen
saver display.
For details, refer to the subsection “Turning the
screen saver function on or off” in section “Opera-
tions Common to Each Mode”.
∗
When you have entered a title in a CD/MP3/WMA,
it appears in the title display. If you have not en-
tered a title, “NO TITLE” appears in the title display
instead.
For information on how to enter a title, refer to the
subsection “Entering titles” in section “ Operations
Common to Each Mode”.
• Main display
• Title display