Smart Power Systems HR-12 50 Hz - Manual (Page 50)

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 49 of 54
The Pump Set option can be accessed by performing the following steps:
Step b: Hold Mode until
Amps Line 1 Blinks
88.
Release switch so 0Pt
appears.
Step c: Press mode twice
to make PSEt appear.
Step d: After selecting
PSEt, Press On/Off until
y appears.
Enabling pump set option
Figure 28
a. If the Command & Control Center is dark, press the Mode switch to put the
Command & Control Center into Normal mode.
b. Press and hold the Mode switch until the Amps Line 1 field blinks with 88 (more
than 10 seconds). Release the switch while the Amps Line 1 field is blinking to
make
0Pt appear. Reference Figure 28.
c. Press (and release) the Mode switch until PSEt appears.
d. Press the On/Off switch until a
y appears, indicating Pump Set option is Active.
e. Return to Normal mode by pressing the Mode switch until the screen shown in
Figure 29 is displayed. Pump Set will still be active.
Hours field alternates
between
PSET and generator
status ( 0n or 0ff)
Actual Generator Output
Frequency
Example of normal display with Pump Set option set
Figure 29