SINGER 580 ROTARY STEAM PRESS - Manual (Page 22)

20
Care & Maintenance
A B C
1
2
3 4
CARE & MAINTENANCE
This chapter contains information with regard to the care and maintenance of your SINGER® Rotary Steam Iron.
For your own safety, always switch off the power switch of the Rotary Steam Iron and unplug when servicing the machine.
GENERAL CARE
To clean the Rotary Steam Iron, use a soft, dry, clean and lint-
free cloth. Particularly stubborn dirt can be removed using a
soft cloth and a commercial cleaning agent.
Use a commercial cleaning agent to clean the ironing sole
plates. Never scratch or scrape the heating shoe.
If it is necessary to renew the ironing roller cover, only use the
original SINGER® ironing cloths and original SINGER® padding
covers obtainable from our website at www.singerco.com.
REPLACING OR RENEWING
THE IRONING ROLLER COVERS
The ironing roller covers may only be replaced when the
heating shoe is cold.
The ironing roller is covered by three layers.
A – Ironing cloth of grey cotton, replaceable. This cover can
be washed at 86° F (30° C). However, there is a risk the cover
shrinks when washed. In this case, we recommend fi tting a
new ironing cloth.
B – The soft padded cover is replaceable. This cover may not
be washed but should only be shaken out slightly.
C – Jute cover, not replaceable
UNWINDING THE IRONING COVERS
1. Pull out the cord loops at both ends of the roller and
open the loops.
2. Switch on the Service function: Press and
hold button 15 “Continuous Steam” and the
power switch. The heater for the heating
shoe is switched Off in this mode.
3. Press the foot pedal and pull the ironing
cloth (A) forward to remove. This causes the
ironing roller to rotate in reverse without
a closing function.
4. Press the foot pedal again and pull the padding cover
(B) forward to remove. The jute cover (C) remains on the
roller.