SINGER 580 ROTARY STEAM PRESS - Manual (Page 15)

13
Functions & Settings
1 2 3 4 5 6
IRONING SETTINGS
Ironing without Steam
Immediately after the Power Switch is switched on, the green
LED Power On illuminates. The LED of the preselected Heat Set-
ting fl ashes red. Select the required temperature setting for
ironing and wait until the corresponding red LED illuminates
steadily. The heating shoe temperature is automatically re-
heated during ironing. If a new temperature setting is selected
(including a lower setting), the corresponding LED fl ashes until
the selected heating shoe temperature is reached.
(Illustration 1 – heat setting of Wool without steam)
If the current temperature setting is selected again, the heater
is switched off and the red LED goes out. The heater is now
switched off but your Rotary Steam Iron remains ready for
use.
(Illustration 2 – heating shoe will be cooling off but the roller
will still move)
If the temperature is set to Synthetic or Silk, it is not possible
to iron with steam.
(Illustration 3)
Note: When ironing without steam, the garment should be
still slightly damp or dampened, i.e., sprayed with water, to
achieve the best results.
Ironing with Demand Steam
The Rotary Steam Iron steams only when the foot pedal is in
position B or C. It is now possible to select between 3 steam
settings: Minimum, Medium, and Maximum. This means that
less energy and water are used when not needed.
Immediately after the Power Switch is switched on, the green
LED Power On illuminates. Select the required temperature
setting Wool, Cotton or Linen for ironing and wait until the
corresponding red LED illuminates steadily. The heating shoe
temperature is automatically maintained during ironing. If a
new temperature setting is selected (including a lower set-
ting), the corresponding LED fl ashes until the selected heating
the temperature is reached.
(Illustration 4 – heat setting of Cotton without steam)
If the current temperature setting is selected again, the heater
is switched off and the red and blue LED goes out. The heater
is now switched off but your Rotary Steam Iron remains ready
for used.
(Illustration 2 – heating shoe will be cooling off but the roller
will still move)
When the Demand Steam Button is pressed, the blue LED il-
luminates. At the same time, the blue steam setting button
(in the medium position) fl ashes until the steam generator
has heated up. The LED then remains illuminated and steam
generation begins. Select one of the three steam settings.
(Illustration 5)
Ironing with Continuous Steam
The Rotary Steam Iron steams even if the foot pedal is not
press and you can select between the three steam settings:
Minimum, Medium and Maximum, to match the amount of
steam to the garment and thus obtain the best result.
Ironing with continuous steam is suitable for ironing wool
pullovers or velvet garments that are not to be pressed. In-
stead, these are smoothed by passing them over the heating
shoe and the continuous steam with the ironing roller in the
raised position.
Immediately after the Power Switch is switched on, the green
LED Power On illuminates. Select the required temperature
setting Wool, Cotton or Linen for ironing and wait until the
corresponding red LED illuminates steadily.
The heating shoe temperature is automatically reheated dur-
ing ironing. If a new temperature setting is selected (includ-
ing a lower setting), the corresponding LED fl ashes until the
selected heating shoe temperature is reached.
(Illustration 1)
When the Continuous Steam button is pressed, the blue LED
illuminates. At the same time, the medium blue steam set-
ting fl ashes until the steam generator has heated up. The
LED then remains illuminated and steam generation begins.
Select one of the three steam settings.
(Illustration 6)
After Ironing
Press the Power Switch. The green LED goes out. Now unplug
from the socket.
Do not fold the Rotary Steam Iron until it has fully cooled down!