SINGER 8763 CURVY - Manual (Page 20)

20
USING AUTOMATIC NEEDLE THREADER
* Be sure to raise the presser foot lifter and raise the needle to
its highest position before threading.
NOTE: Don’t pull thread with strong force or thread
may be pulled off from needle hole after threading.
NOTE: Make sure that the guide doesn’t touch
fabric, etc.
Note:
1. Heavy thread cannot be threaded through fine needle.
2. Don’t lower the threading lever while the machine is
in operation or the threading hook may be broken.
3. Put a drop of sewing machine oil onto the felt disc,
if the machine is used after a long interval.
4. If the threading hook is deviated from needle hole,
adjust the position of the hook.
NOTE: For smooth threading, it is recommended that
the machine be set for straight stitch (in center needle
position) when using the automatic needle threader.
1. Hook thread to the thread guide on the needle bar and pull
it toward you leaving about 4” (10 cm) clear.
2. Hook thread to the twin thread guide (A and B).
3. Pull thread gently into the thread cutter/holder to cut and
hold it in place.
4. Pull down the threading lever until the twin thread guide
rotates and stops.
5. Release the threading lever and needle will be threaded
automatically. If it should not return to the original position,
raise it gently by hand.
6. Pull thread loop away from you.
6
3 2 1
5 4
Threading lever
Releveur de fil
Palanca de ensartado
Twin thread guide
Guide-fil double
Guía doble hilo
Threading hook
Crochet d’enfilage
Gancho del ensartador
Thread cutter/holder
Coupe-fil / support
Cortador de hilo
Thread guide
Guide-fil
Guía hilo
B
A
Felt disc
Rondelle de feutre
Disco de fieltro