QOMO QD1200 - Manual (Page 9)

Note:
You can connect a laptop computer to the RGB IN port of side panel
with a RGB cable.
Step 4: Connect to the first video equipment with S-Video input.
Output of the S-Video signal from the visualizer to the projector is already
done in the step 2, where the RGB cable comes out from the visualizer and
goes to the projector. After the connections as steps 2, 3, 4 are made, input
signals from the computer、visualizer CCD and S-Video are going to the
RGB1 input on the projector and will be displayed on the projector screen
as RGB1. These signals can be seen in turn when pressing
“CCD/PC1/PC2” and “S-VIDEO/VIDEO” on the control panel of the
visualizer.
AUDIO
IN
S-VIDEO
OUT OUT
VIDEO AUDIO VIDEO
Video equipment
S-Video out
Audio out
Audio input
(or amplifier/speaker equipment)
Projector
S-Video Cable
S-VIDEO AUDIO
IN
PROJECTOR
Rear Panel
AUDIO IN OUT-12V- IN OUT -COMPUTER- IN
Step 5: Connect to the second video equipment with video input.
9
Video in
Projector Color monitor
S-VIDEO AUDIO
OUT OUT
AUDIO VIDEO S-VIDEO VIDEO
IN IN
AUDIO
Rear Panel
AUDIO IN PROJECTOR OUT -COMPUTER- IN OUT-12V- IN
Video equipment
Audio out
Video Cable
Video out