QOMO QD1200 - Manual (Page 16)

text file, switch to the text mode to get a clearer text effect.
COLOR AND B&W MODE SWITCH
Press “B&W” once to enter the Black & White mode; press again to return
to the Color mode. (On the remote control)
SWITCHABLE VIDEO INPUTS
Press the “S-VIDEO/VIDEO” button to switch among S-Video and Video
signals.
SWITCHABLE RGB INPUTS
Use the “CCD/PC1/PC2” button to switch between CCD and different RGB
signals. Each time the “CCD/PC1/PC2” button is pressed, it provides
seamless transitions among different sources such as Camera (CCD)、
COMPUTER(IN)、and RGB (IN).
Notes: RGB OUT always outputs RGB IN signals.
PROJECTOR ON/STANDBY
Press the “POWER” button to turn on the QD1200’s power and press the
“Ppw” button to turn the projector power on. To turn the projector standby
after use, press the “Ppw” button more than 2 seconds, and then the
projector enters to the standby mode. (On the remote control, press the
“PROJECTOR POWER” button)
PROJECTOR INPUTS SELECTION
When the projector is connected to several input sources, use the “Pin”
button to switch signal inputs of the projector. (On the remote control, press
the “PROJECTOR INPUT” button)
IMAGE ROTATION
In order to rotate the image, press the “Rot” button once, the displayed
image will be rotated ±90 degrees clockwise. Press the “Rot” button again,
the rotated image will be restored to the initial position.
16