Modern AG Super Sunshine - Manual (Page 48)

48 - superrr sunshine
Maintenance Section
Blade SerVicinG
Inspect blade before each use to determine that they are properly installed and in good condition.
Replace any blade that is bent, excessively nicked, worn or has any other damage. small nicks can be
ground out when sharpening. Using only original equipment blades on this cutter. they are made of
special heat-treated alloy steel. substitute blades may not meet specification and may dangerous.
Blade Sharping
always sharpen both blades at same time to maintain balance. Follow original sharpening pattern.
always sharpen blades by grinding. DO NOt heat and pound out edge. Do not sharpen blade to a
razor edge, but leave a 1/16” blunt edge. Do not sharpen back side of blade.
IMPORTANT: When sharpening blades, grind each blade the same amount to maintain balance. The difference
in blade weights should not exceed 1 ounce. Unbalanced blades will cause excessive vibration which can damage
gear box bearings. Vibration may also cause structural cracks in cutter housing.
FOLLOW ORIGINaL PattERN
MAINTAIN CORNER
Never work under equipment support
by a hydraulic device because it may
drop if the control is actuated (even
with the engine stopped) or in the event
of hose failure, etc. Always use a secure
support for equipment which must be
serviced while in the raised position.