Operation, Opera tion, Warning – Modern AG Super Sunshine User Manual

Page 38: Engaging the power take off (pto)

38 - superrr sunshine

oPeration Section

Rotary Cutters are capable under adverse conditions of throwing objects for great

distances (300 feet or more) and causing serious injury or death. Follow safety messages

carefully.

StoP MowinG iF PaSSerSBy are witHin 100 yardS unleSS:

- Front and Rear Deflectors, Chain Guards, or Bands are installed and in good, workable

condition;

-Passersby are outside the existing thrown-object zone;
- all areas have been thoroughly inspected and all foreign material such as rocks, cans,

glass, and general debris has been removed.

NOTE: Where there are grass and weeds high enough to hide debris that could be struck by the

blades, the area should be: inspected and large debris removed, mowed at an intermediate

height, inspected, closely with any remaining debris being removed, and mowed again at

desired final height. (This will also reduce power required to mow, reduce wear and tear on

the Cutter drivetrain, spread cut material better, eliminate streaking, and make the final cut
more uniform).

engaging the Power take off (Pto)

Before engaging the PtO, make certain that the area is clear of bystanders and passersby. the implement

must be completely lowered and the deck positioned at a safe operating height. NEVER engage the PtO

with the implement in the raised position.
set the tractor engine speed at approximately 1,000 RPm before engaging the PtO. shift the PtO control

to the on position, and slowly increase the engine speed until the PtO is operating at the rated speed. If

you hear unusual noises or see or feel abnormal vibrations, disengage the PtO immediately. Inspect the

implement to determine the cause of the noise or vibration and repair the abnormality.

Do not let the Blades turn when the Cutter Deck is raised for any reason, including clearance or for

turning. Raising the Cutter deck exposes the Cutting Blades which creates a potentially serious hazard

and could cause serious injury or even death from objects thrown from the Blades.

Do not put hands or feet under cutter decks. Blade Contact can result in serious injury

or even death. stay away until all motion has stopped and the decks are securely

blocked up.

OPERATION

FL15M 02/07

Operation Section 4-34

OPERA

TION

Rotary Mowers are capable under adverse conditions of throwing

objects for great distances (300 feet or more) and causing serious injury

or death. Follow safety messages carefully.

STOP MOWING IF PASSERSBY ARE WITHIN 100 YARDS UNLESS:
-Front and Rear Deflectors, Chain Guards, or Bands are installed and in good, workable

condition;
-Mower sections or Wings are running close to and parallel to the ground without exposed

Blades;
-Passersby are outside the existing thrown-object zone;
-All areas have been thoroughly inspected and all foreign material such as rocks, cans,

glass, and general debris has been removed.
NOTE: Where there are grass and weeds high enough to hide debris that could be struck

by the blades, the area should be: inspected and large debris removed, mowed at an

intermediate height, inspected, closely with any remaining debris being removed, and

mowed again at desired final height. (This will also reduce power required to mow, reduce

wear and tear on the Mower drivetrain, spread cut material better, eliminate streaking, and

make the final cut more uniform).

(SRM-1)

11.3 Engaging the Power Take Off (PTO)

Before engaging the PTO, make certain that the area is clear of bystanders and passersby. The implement

must be completely lowered and the deck positioned at a safe operating height. NEVER engage the PTO with

the implement in the raised position.
Set the tractor engine speed at approximately 1,000 RPM before engaging the PTO. Shift the PTO control to

the on position, and slowly increase the engine speed until the PTO is operating at the rated speed. If you

hear unusual noises or see or feel abnormal vibrations, disengage the PTO immediately. Inspect the

implement to determine the cause of the noise or vibration and repair the abnormality. OPS-U- 0027

Do not let the Blades turn when the Mower Deck is raised for any reason,

including clearance or for turning. Raising the Mower deck exposes the

Cutting Blades which creates a potentially serious hazard and could

cause serious injury or even death from objects thrown from the Blades.

(SRM-7)

Do not put hands or feet under mower decks. Blade Contact can result

in serious injury or even death. Stay away until all motion has stopped

and the decks are securely blocked up.

(SGM-9)