Modern AG 20' Predator - Manual (Page 13)

20’ Predatorrr - 13
- Be aware of the operating conditions. Do not operate the tractor with weak or faulty brakes
or worn tires. When operating down a hill or on wet or rain slick roads, the braking distance
increases: use extreme care and reduce your speed. When operating in traffic always use the
tractor’s flashing warning lights and reduce your speed. Be aware of traffic around you and watch
out for the other guy.
• turn curves or go up hills only at a low speed and using a gradual steering angle. Rear mounted
implements move the center of gravity to the rear and remove weight from the front wheels.
make certain, by adding front ballast, that at least 20% of the tractor’s weight is on the front
wheels to prevent rearing up, loss of steering control or tractor tip-over.
• When the wings are folded for transport, the center of gravity is raised and the possibility
of overturn is increased. Drive slowly and use extreme caution when turning on hillsides.
Overturning the implement could cause the implement to overturn the tractor and vice versa
resulting in serious injury or even death. never fold wings on a hillside...the implement may
overturn.
• Slow down on rough or uneven surfaces to prevent loss of steering control which could result in
property damage or possible injury. Do not transport unless 3-Point lift lever is fully raised and
in the latched transport position. Dropping implement in transport can cause serious damage to
the tractor and/or implement and possibly cause the operator or others to be injured or killed.
• In wet conditions where there is a likelihood of material collecting on the implement, make
certain that excess material is removed before traveling on public roadways.
• allow sufficient clearance for the implement to swing outward while turning. Implements carried
behind the tractor will swing outside the tire path when making turns. Contacting a solid object
while turning will cause equipment damage and possible injury.
• always keep a careful lookout and use extreme care when transporting around overhead
obstructions and electrical power lines. the implement wing can be over 10 feet high. never
allow the implement wing to come within 10 feet of any power line.
Maintenance and Service Safety
• Periodically inspect all moving parts for wear and replace when necessary with authorized
service parts. Look for loose fasteners, worn or broken parts, and leaky or loose fittings. make
sure all pins have cotter pins and washers. Serious injury may occur from not maintaining this
machine in good working order.
SafEty SEction