beautypg.com

Mercedes-Benz E-class 1998 Taillamp Assemblies User Manual

Page 2

background image

122

Battery

Warning!

Failure to follow these instructions

can result in severe injury or death.

Never lean over batteries while

connecting, you might get injured.

Battery fluid contains sulfuric acid.

Do not allow this fluid to come in

contact with eyes, skin or clothing.

In case it does, immediately flush

affected area with water and seek

medical help if necessary.

A battery will also produce hydrogen

gas, which is flammable and

explosive. Keep flames or sparks

away from battery, avoid improper

connection of jumper cables,

smoking etc..

Important!

Battery replacement information:

The maintenance-free battery is located
under the rear seat cushion. To minimize
the chance for acid leakage which could
cause severe burns during a crash or
rollover, a special acid leakage resistant
battery was factory installed. A
replacement battery for the car must not
leak acid when upside down for at least
15 minutes. Your authorized Mercedes-
Benz dealer can provide such a special
battery.

The service life of the battery is
dependent on its condition of charge. The
battery should always be kept sufficiently
charged, in order to last an optimum
length of time.

Therefore, we strongly recommend

that you have the battery charge

checked frequently, and corrected if

necessary, especially if you use the

vehicle less than approximately 200

miles (300 km) per month, mostly for

short distance trips, or if it is not

used for long periods of time.

Only charge a battery with a battery
charger after the battery has been
disconnected from the vehicle electrical
circuit.

Always disconnect the battery negative
lead first and connect last.

When removing and connecting the
battery, always make sure that all
electrical consumers are off and the
electronic key is in steering lock
position 0. The battery, its filler caps, the
vent tube and the opposite plug must
always be securely installed when the
car is in operation. During removal and
installation always protect the
disconnected battery positive (+)
terminal with the cover attached to the
battery.