Mercedes-Benz E-class 1998 Taillamp Assemblies - Manual (Page 15)

135
Rear Seat Cushion
Removal: Pull locking tabs up (on left
and right side of seat) and lift seat at the
front.
Installation: Guide seat belt buckles
through openings in seat cushion. Slide
rear edge of cushion under the backrest
as far as it will go, and push front of
cushion down until it locks in place.
Caution!
Watch out for sharp edges when
removing or installing the rear seat
cushion, and make sure that it is
securely locked in place again, to prevent
personal injury
.
Emergency Operation of
Sliding/Pop-Up Roof
The sliding/pop-up roof can be opened
or closed manually should an electrical
malfunction occur.
The sliding/pop-up roof drive is located
behind the lens of the left interior lamp
between the sun visors.
1. Pry off lens (1) by using a screw
driver.
2. Obtain crank (2) (supplied with
vehicle) and insert it through
hole.
To slide the roof closed or to raise the
roof at the rear: turn crank clockwise.
To slide the roof open or to lower the
roof at the rear: turn crank
counterclockwise.