Mercedes-Benz GL-Class 2007 Owners Manual User Manual
Page 183
182
Controls in detail
Control system
̈
Press button
j or k repeatedly
until the message
Compass setting
Zone
appears in the multifunction
display.
The selection marker is on the current
setting.
̈
Press button
æ or ç to set the
respective compass zone.
For information on how to call up the
compass, see “Compass” (
Compass calibration
This function is not available if your vehicle
is equipped with the COMAND system and
navigation module*.
In order to calibrate the compass properly,
mind the following:
ț
Calibrate the compass in open terrain.
Nearby buildings, bridges, power lines
and large antenna masts, for example,
could impair compass calibration.
ț
Switch off electrical consumers (e.g.
climate control, windshield wipers, or
rear window defroster).
ț
Close all doors and the tailgate.
̈
Start the engine (
̈
Press button
æ or ç to move
the selection marker to the
Vehicle
submenu.
̈
Press button
j or k repeatedly
until the message
Compass Calibration
appears in the
multifunction display.
The selection marker is on setting
switched off
.
̈
Press button
æ to set the selection
marker to
Start
.
The following message appears in the
multifunction display:
Compass Calibration active
Please drive in a full circle
i
Make sure you are in area where you can
drive a full circle with your vehicle without dis-
turbing traffic in order to calibrate the compass.
୴୴