Mercedes-Benz C-Class 2007 Owners Manual - Manual (Page 358)

357
Practical hints
Where will I find ...?
3 Arrow
4 Minispare wheel with spare wheel bolts
in container on wheel rim
5 Vehicle tool kit storage well casing
6 Vehicle tool kit
̈ Remove vehicle tool kit 6.
Storing the vehicle tool kit
̈ Place vehicle tool kit 6 in vehicle tool
kit storage well casing 5.
̈ Place storage well casing 2 over the
vehicle tool kit storage well casing 5
and turn retaining screw 1 clockwise
as far it will go to secure the Minispare
wheel.
Vehicle jack
i Arrow 3 on vehicle tool kit storage well
casing 5 must point in the direction of travel.
Otherwise you cannot place the storage well
casing
2 on top and secure the Minispare
wheel with retaining screw 1.
! To prevent damage, always disengage trunk
floor handle from upper edge of trunk and lower
trunk floor before closing the trunk.
Warning!
G
The jack is designed exclusively for jacking
up the vehicle at the jack take-up brackets
built into both sides of the vehicle. To help
avoid personal injury, use the jack only to lift
the vehicle during a wheel change. Never
get beneath the vehicle while it is supported
by the jack. Keep hands and feet away from
the area under the lifted vehicle. Always
firmly set parking brake and block wheels
before raising vehicle with jack.
Do not disengage parking brake while the
vehicle is raised. Be certain that the jack is
always vertical (plumb line) when in use,
especially on hills. Always try to use the jack
on level surface. Make sure the jack arm is
fully seated in the jack take-up bracket.
Always lower the vehicle onto sufficient
capacity jackstands before working under
the vehicle.