Mercedes-Benz CL-Class 2009 - Manual (Page 304)

Starter switch positions
302
the engine can be started using the
KEYLESS-GO start/stop button.
The function of the SmartKey overrules the
KEYLESS-GO function.
The SmartKey must be located in the vehicle.
1 KEYLESS-GO start/stop button
2 Starter switch
X Insert KEYLESS-GO start/stop button 1
into starter switch 2 (if not inserted
already).
i When you switch from SmartKey mode
back to KEYLESS-GO mode, the system
requires 2 seconds of detection time
before you can use the KEYLESS-GO button
as usual.
X Make sure the automatic transmission is in
park position
P.
X Do not depress the brake pedal.
KEYLESS-GO start/stop button
=
USA only
? Canada only
Position 0
Before you press the KEYLESS-GO start/stop
button, the vehicle’s on-board electronics
have status
0 (as with SmartKey removed).
Position 1
X Press the KEYLESS-GO start/stop button
once.
This supplies power for some electrical
consumers, such as radio functions.
i If you now press the KEYLESS-GO start/
stop button
R once more, the ignition (position 2) is
switched on
R twice more the power supply is again
switched off
Ignition (or position 2)
X Press the KEYLESS-GO start/stop button
twice.
This supplies power for all electrical
consumers.
All lamps (except high-beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instrument
cluster come on. If a lamp in the instrument
cluster fails to come on when the ignition
is switched on, have it checked and
replaced if necessary. If a lamp in the
instrument cluster remains on after
starting the engine or comes on while
driving, refer to “Lamps in instrument
cluster” (
Y page 527).
i If you now press the KEYLESS-GO start/
stop button once, the power supply is again
switched off.
Controls in detail