Charging the battery, Breakdown assistance, Battery (vehicle) – Mercedes-Benz CLS-Class 2013 Owners Manual User Manual
Page 318

workshop if you wish to leave your vehicle
parked up for a long period of time.
i
Remove the SmartKey if you park the
vehicle and do not require any electrical
consumers. The vehicle will then use very
little energy, thus conserving battery
power.
i
If the power supply has been interrupted,
e.g. if you reconnect the battery, you will
have to:
R
set the clock. Information on setting the
clock can be found in the separate
operating instructions.
On vehicles with COMAND and a
navigation system, the clock is set
automatically.
R
reset the function for folding the exterior
mirrors in/out automatically, by folding
the mirrors out once (
Y
page 105).
Charging the battery
G
WARNING
Never charge a battery still installed in the
vehicle unless a battery charger unit approved
by Mercedes-Benz is being used. Gases may
escape during charging and cause explosions
that may result in paint damage, corrosion or
personal injury.
A battery charger unit specially adapted for
Mercedes-Benz vehicles and tested and
approved by Mercedes-Benz is available as an
accessory. It permits the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Center for further
information and availability.
Charge the battery in accordance with the
separate instructions for the battery charger.
G
WARNING
There is a risk of acid burns during the
charging process due to the gases which
escape from the battery. Do not lean over the
battery during the charging process.
G
WARNING
Battery acid is caustic. Avoid contact with the
skin, eyes or clothing.
!
Only use battery chargers with a
maximum charging voltage of 14.8 V.
!
Only charge the battery using the jump-
starting connection point.
The jump-starting connection point is in the
engine compartment (
Y
page 317).
Read the battery charger's operating
instructions before charging the battery.
X
Open the hood (
Y
page 298).
X
Connect the battery charger to the positive
terminal and ground point in the same
order as when connecting the donor
battery in the jump-starting procedure
(
Y
page 317).
316
Battery (vehicle)
Breakdown assistance