Harbor Freight Tools Model 94996 - Manual (Page 7)

Page 7 SKU 94996 For technical questions, please call 1-800-444-3353
Draining Cleaning Fluid from Tank
1. Insert the end of the Waste Hose (left side of Fluid Basin) into an appropriate solvent
bucket with lid.
2. Turn off the Output Hose Switch.
3. Turn on the Waste Hose Switch.
Troubleshooting
Problem Possible Cause Probable Solution
If Tank is not running 1. Setup procedures incorrect
2. Air Inlet Switch off
3. Air compressor off or pressure
incorrectly set
1. Repeat Setup and Operation
procedures on page 4
2. Turn on Air Inlet Switch
3. Turn on air compressor and
set at 40 PSI
Cleaning of Spray Gun
incomplete
1. Wrong type of cleaning solu-
tion used
2. Paint dried hard in Spray Gun
and Cup
3. Cleaning solution too dirty
1. Check the paint can for the
appropriate type of cleaning
solution
2. Repeat cleaning process
3. Replace cleaning solution
Maintenance
1. Drain the Cleaning Fluid from the Tank and wipe Tank clean before storing the unit.
2. Store unit in a clean, dry, and cool location, away from any flame or spark source.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS
SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING
OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
REV 07g; 08d