Kontron JRexplus-LX - Manual (Page 15)

KTD-S0004-A Page 12 Serial-ATA Interface
JRexplus LX Software Guide
If a USB floppy drive is still not detected properly the parameters can be determined as follows:
Plugin the USB floppy drive on any Desktop PC running the Windows
® XP operating system and open the
device manager in the system control panel. The floppy drive should be listed below the entry Universal
Serial Bus Controller. Goto it's properties, select the details tab, then Hardware IDs where you can see
USB\VID_ ... &PID_ .... These values must be added as a new line to the file TXTSETUP.OEM.
Presumeably this addition must correspond with the file
USBSTOR.INF. If the floppy drive identification is
not implemented in this file the installation might fail.
Manufacturer ID in USBSTOR.INF available
HP ✔
Iomega Indefinite
NEC ✔
Samsung Indefinite
SMSC ✔
Sony ✔
Y-E Data ✔