Kontron JRexplus-LX - Manual (Page 13)

KTD-S0004-A Page 10 Graphics Interface
JRexplus LX Software Guide
The DisplayID TM Editor saves the parameters in a intermediate file format. The file extension is 'KDD' (Kon-
tron DisplayID TM Data). This file format cannot be used to program the onboard EEPROM.
For transfering this file format into the binary file format for the EEPROM apply the Converter.
3.3.5 Building DisplayID TM File
❶ Start the Windows ® tool DisplayID.exe.
❷ Use the Editor if you want to modify an existing DisplayID TM file or select New to create a
complete new record.
❸ Change respectively enter new parameters.
❹ Save the parameters in a file with the extension 'KDD'.
❺ Open the saved 'KDD'-file using the Converter.
❻ Save the binary file with the extension 'KDB' (Kontron DisplayID TM Binary).
❼ Program the onboard EEPROM using the board specific DOS update tool.
3.3.6 Erasing DisplayID TM Record
Programming the first 128 bytes in the EEPROM with the values 00h or FFh deletes a valid DisplayID TM
record.
3.3.7 EEPROM Update Tool
The syntax of the DOS EEPROM update tool is:
BLX8-DID
/W = read a file (must be KDB-format) and write the content to the EEPROM
/R = read the EEPROM and write the content to a file
/C = read a file and compare the content with the EEPROM
/D = clear the EEPROM content (without filename)