Converting an in-use phone from sccp to sip, Converting an in-use phone from sip to sccp – Cisco IP Phone 7961G-GE User Manual
Page 20
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
2-20
Cisco Unified IP Phone 7961G/7961G-GE and 7941G/7941G-GE for Cisco Unified Communications Manager 6.1
OL-14620-01
Step 2
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the “Configuring Startup Network Settings” section on page 3-14.
Step 3
Save the configuration updates and reset the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from Cisco Unified
Communications Manager Administration, choose Bulk Administration >
Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.
Converting an In-Use Phone from SIP to SCCP
To convert a phone that is in use in your network from SIP to SCCP, perform these
steps. For more information, Cisco Unified Communications Manager
Administration Guide.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, delete the existing
SIP phone from the Cisco Unified Communications Manager database.
Step 2
In Cisco Unified Communications Manager Administration, create the phone as
an SCCP phone.
Step 3
Power cycle the phone.