Kontron MSM800BEV - Manual (Page 65)

MSM800BEV / System Resources
www.kontron.com 63
7.3.5 The LAN Cable (RJ45)
Attention: Early board versions use the MSM855-LANCON. Later versions must use the MSM800-LANCON, because
the LAN transformer (pulse) is integrated on the MSM800 product. See below for the version numbers.
Use the MSM800-LANCON starting with the
following versions:
BEV Version 1.0
For earlier versions use the MSM855-LANCON:
RJ45 connector 10BaseT (IEEE 802.3i), 100BaseTX (IEEE 802.3u):
MDI-Pin
EIA/TIA 568A
colors (wire/line)
Pin Twisted Pair
TX+ White /green 1 3
TX- Green 2 3
RX+ White/orange 3 2
GND .. 4 1
GND .. 5 1
RX- Orange 6 2
GND .. 7 4
GND .. 8 4
Cabling:
Do not exceed 100m (328 feet); minimum quality of CAT5, preferably S/FTP or STP CAT6.
Note: Be sure to have a well balanced shield/ground concept.