Kontron AM4020 IPMI Firmware - Manual (Page 46)

IPMI Firmware AM4020
Page 38 ID 1036-5671, Rev. 2.0
P R E L I M I N A R Y
The four Ethernet ports provided by the AM4020 are assigned to the following channels:
Channel 1: AMC port 0
Channel 2: AMC port 1
Channel 3: Front port 0, GbE C, upper connector (J4)
Channel 4: Front port 1, GbE D, lower connector (J3)
10.3 Basic Setup from uEFI Shell
With the 'kipmi net' command from uEFI Shell some basic settings such as IP address, sub-
net mask and gateway address can be setup for all of the four Ethernet channels.
10.4 Setup by “ipmitool” or IPMI Commands
The open tool “ipmitool” offers commands for the setup of the four Ethernet channels. All pos-
sible options are shown by issuing:
If “ipmitool” is not usable, the LAN parameters can be set by using standard IPMI commands
as defined in the IPMI specification.
To show the current LAN parameters for a channel, “ipmitool” offers the command:
10.5 Setup of User Accounts and Password
The open tool “ipmitool” offers commands for the listing and manipulation of user accounts for
channels 1 through 4. An overview can be obtained by issuing:
The predefined user accounts for a channel can be listed using the following command:
For every channel, the AM4020 has these predefinitions in non-volatile memory:
Please note that the ADMINISTRATOR password is preset with admin.
Changed accounts and passwords stay valid after payload power-off.
The accounts must be activated using the following command:
ipmitool lan set
ipmitool lan print
ipmitool user
ipmitool user list
ID Name Callin Link Auth IPMI Msg Channel Priv Limit
1 false true true USER
2 admin false true true ADMINISTRATOR
ipmitool user enable