Kontron AM4020 IPMI Firmware - Manual (Page 25)

AM4020 IPMI Firmware
ID 1036-5671, Rev. 2.0 Page 17
P R E L I M I N A R Y
3.2 Set Control State (Firmware Hub, Boot Order)
Table 6: Set Control State
COMMAND LUN NetFn CMD
Set Control State (Firmware Hub, Boot Order) 00h OEM = 3Eh 20h
REQUEST DATA
Byte Data Field
1 Control ID:
00h = Firmware Hub (SPI Flash) Selection
9Dh = Boot Order Configuration
2 Control State for SPI Flash selection:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = SPI flash selection is not inverted
01h = SPI flash selection is logically inverted
Please note that this selection will be automatically toggled by the IPMI controller during a
failing boot process. Other payload sided settings may additionally modify this selection.
Control State for Boot Order Configuration:
(These settings are stored in EEPROM and applied (to logic) each time the IPMI controller
detects power-on)
00h = No override, boot as usual
01h = Next boot device is: Floppy
02h = Next boot device is: HDD
03h = Next boot device is: CD
04h = Next boot device is: Network
05h = Next boot device is: USB Floppy
06h = Next boot device is: USB HDD
07h = Next boot device is: USB CDROM
RESPONSE DATA
Byte Data Field
1 Completion Code