Kontron AM5030 - Manual (Page 21)

AM5030 Introduction
ID 1036-3302, Rev. 1.0 Page 1 - 5
P R E L I M I N A R Y
• PICMG AMC.3 R1.0 Advanced Mezzanine Card Specification for Storage
• PICMG MTCA.0 R1.0 Micro Telecommunications Computing Architecture Base Spec-
ification
• PICMG MTCA.1 R1.0 Air Cooled Rugged MicroTCA Specification
• Designed to be compliant with the following SCOPE technical document:
•
SCOPE AMC Port Map Gap-Analysis v1.0
1.3 System Relevant Information
The following system-relevant information is general in nature but should still be considered
when developing applications using the AM5030.
1.4 Board Diagrams
The following diagrams provide additional information concerning board functionality and
component layout.
1.4.1 Functional Block Diagram
The following figure shows the block diagram of the AM5030.
Table 1-1: System Relevant Information
SUBJECT INFORMATION
Hardware Requirements The AM5030 can be installed on dedicated MicroTCA backplanes with the follow-
ing AMC Card-edge connector port mapping:
• Common Options Region ports 0-1:
• Two Gigabit Ethernet SerDes ports
• Common Options Region ports 2-3:
• Two Serial ATA ports
• Fat Pipes Region ports 4-7:
• One x4 PCI Express 2.0 port
• Fat Pipes Region ports 8-11:
• One XAUI port
• Extended Options Region port 12-13:
• Two Serial ATA ports
• Extended Options Region port 14:
• One Debug port
• Extended Options Region port 15:
• One Serial port
• Extended Options Region port 17-20:
• One XAUI port
• Clock:
• Bidirectional PCI Express reference clock, FCLKA
For further information on the AMC interconnection, refer to Chapter 2.11, “AMC
Interconnection”.
PCI Express Configuration The AM5030 only supports the PCI Express root complex configuration.
Operating Systems The board is offered with various Board Support Packages including Windows and
Linux operating systems. For further information concerning the operating sys-
tems available for the AM5030, please contact Kontron.