Kontron AM4510 - Manual (Page 18)

6 AM4510
www.kontron.com
2.4.2 Hardware Sensors
Table 2-1:Hardware Sensors
2.4.2.1 IPMB-L Link Sensor
The AM451x has an IPMB-L link to communicate with the AMC Carrier and other chassis devices on the chassis
IPMB-0 bus. MMC monitors the bus for any link failure and send the bus failure event to the AMC Carrier upon
recovery.
Sensor Name Voltage/Signals Monitored Scanning Enabled under Power State Health LED (Green to Amber)
IPMI Info-1
Internal IPMC firmware
diagnostic
Power On/Off No change
IPMI Info-2
Internal IPMC firmware
diagnostic
Power On/Off No change
FRU Agent
Board FRU DATA agent that verify
Data validity
Power On/Off No change
AMC Stor Err
Management sub-system health;
non volatile memory error.
Power On/Off No change
Board 3.3V 3.3V Power On Exceeds critical threshold
Board 5V +5 V Power On Exceeds critical threshold
Board 12v +12 V Power On Exceeds critical threshold
Board 12V Drv + 12V Hard Drive Power On Exceeds critical threshold
Board 3.3VSUS +3.3 VSB Power On/Off Exceeds critical threshold
Board BlueLed Blue LED Voltage Power On/Off Exceeds critical threshold
ModuleHotSwap AMC HS State Power On/Off No change
IPMBL State Operational state of IPMB-L Power On/Off No change
Health Error
Aggregation of healthy related
sensor
Power On/Off Asserted/deasserted
Temp AirInlet
Board Inlet Temperature
(See note below)
Power On/Off Exceeds critical threshold
Temp Exhaust
Board Outlet Temperature
(See note below)
Power On/Off Exceeds critical threshold
Temp PSU In
Power Switcher In Temperature
(See note below)
Power On/Off Exceeds critical threshold
Temp PSU Out
Power Switcher Out Temperature
(See note below)
Power On/Off Exceeds critical threshold
MMCReboot IPMC reboot detection Power On/Off No change
Ver change
IPMC firmware upgrade
detection
Power On/Off No change
Note:
Temperature sensors thresholds are programmed depending on the hard disk configuration.