Kontron AM4521 - Manual (Page 22)

11 AM4521
www.kontron.com
3. Installing the Board
3.1 Onboard Connectors and Headers
Table 3-1:Onboard Connectors & Headers
3.2 Board Hot Swap and Installation
Some precautions must be taken when connecting or disconnecting a board:
1 Rail guides must be installed on the enclosure to slide the board to the backplane.
2 Do not force the board if there is mechanical resistance while inserting the board.
3 Use extractor handle to disconnect and extract the board from its enclosure.
3.2.1 Installing an AMC
To install an AMC:
1 Remove the AMC filler panel.
2 Carefully engage the AMC into the card guide. Push the AMC until it fully mate with it's connector. Secure
the AMC handle to the locking position.
3 In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It will turn OFF at the
end of the hot swap sequence.
Description Connector Comments
AMC Connector J4 AMC Connector
SATA Connector J5 Serial ATA Connector
WARNING
Always use a grounding wrist wrap before installing or removing the board from a
chassis.