2 gigabit ethernet, 3 ethernet operational status leds, Gigabit ethernet - 9 – Kontron CP6925 User Manual
Page 35: Ethernet operational status leds - 9, Pinouts of j6a/b based on the implementation - 9, Dual gigabit ethernet connector j6a/b - 9, Cp6925 functional description, J6a j6b
Doc.ID: 35008, Rev 1.0
Page 2 - 9
CP6925
Functional Description
CUSTOMER SPECIFIC
P R E L I M A R Y
2.3.2
Gigabit Ethernet
The CP6925 board includes two 10Base-T/100Base-
TX/1000Base-T Ethernet ports.
The Ethernet connectors are realized as RJ45 con-
nectors. The interfaces provide automatic detection
and switching between 10Base-T, 100Base-TX and
1000Base-T data transmission (Auto-Negotiation).
Auto-wire switching for crossed cables is also support-
ed (Auto-MDI/X).
RJ45 Connector J6A/B Pinouts
The J6A/B connector supplies the 10Base-T,
100Base-TX and 1000Base-T interfaces.
2.3.3
Ethernet Operational Status LEDs
The operational status LEDs for all Ethernet ports are on the front panel. There are two status
LEDs available for each channel: an activity LED, and a speed LED. Their functions are defined
as follows:
Activity (green): This LED monitors network connection and activity. The LED lights up when
a valid link (cable connection) has been established. The LED goes temporarily off if network
packets are being sent or received through the RJ45 port. When this LED remains off, a valid
link has not been established.
Speed (green/yellow): This LED lights up to indicate a successful 100Base-TX or 1000BASE-
T connection. When green it indicates a 100Base-TX connection and when yellow it indicates
a 1000Base-T connection. When not lit and the Activity LED is active, the connection is oper-
ating at 10Base-T.
Table 2-4: Pinouts of J6A/B Based on the Implementation
MDI / STANDARD ETHERNET CABLE
PIN
MDIX / CROSSED ETHERNET CABLE
10BASE-T
100BASE-TX
1000BASE-T
10BASE-T
100BASE-TX
1000BASE-T
I/O SIGNAL I/O SIGNAL I/O SIGNAL
I/O SIGNAL I/O SIGNAL I/O SIGNAL
O
TX+
O
TX+
I/O
BI_DA+
1
I
RX+
I
RX+
I/O
BI_DB+
O
TX-
O
TX-
I/O
BI_DA-
2
I
RX-
I
RX-
I/O
BI_DB-
I
RX+
I
RX+
I/O
BI_DB+
3
O
TX+
O
TX+
I/O
BI_DA+
-
-
-
-
I/O
BI_DC+
4
-
-
-
-
I/O
BI_DD+
-
-
-
-
I/O
BI_DC-
5
-
-
-
-
I/O
BI_DD-
I
RX-
I
RX-
I/O
BI_DB-
6
O
TX-
O
TX-
I/O
BI_DA-
-
-
-
-
I/O
BI_DD+
7
-
-
-
-
I/O
BI_DC+
-
-
-
-
I/O
BI_DD-
8
-
-
-
-
I/O
BI_DC-
Figure 2-3: Dual Gigabit Ethernet
Connector J6A/B
1
8
1
8
J6A
J6B
15
16
CH