Kontron CPS3003-SA - Manual (Page 19)

D R A F T — F O R I N
T E R N A L U S E O N L Y
19 www.kontron.com
User Guide
CPS3003-SA
In addition, boards ordered with the ruggedized service comply with the following standards as well.
Note: Customers desiring to perform further environmental testing of the CPS3003-SA must con-
tact Kontron for assistance prior to performing any such testing.
Boards without conformal coating must not be exposed to a change of temperature which
can lead to condensation. Condensation may cause irreversible damage, especially when
the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting from destruc-
tive environmental testing.
1.6 Related Publications
The following publications contain information relating to this product.
Table 3: Additional Standards for Boards Ordered with Ruggedized Service
TYPE ASPECT STANDARD REMARKS
Environmental Vibration
(Sinusoidal) IEC60068-2-6
IEC61131-2 Ruggedized version test parameters:
9-150 (Hz) frequency range
1 (g) acceleration
1 (oct/min) sweep rate
10 cycles/axis
3 axis
Single Shock IEC60068-2-27
IEC61131-2 Ruggedized version test parameters:
15 (g) acceleration
11 (ms) shock duration half sine
3 number of shocks per direction (total: 18)
6 directions
5 (s) recovery time
Table 4: Related Publications
PRODUCT PUBLICATION
CompactPCI Serial Systems PICMG® CPCI-S.0 R 1.0 CompactPCI® Serial Specification
CompactPCI Systems PICMG® 2.0, Rev. 3.0 CompactPCI® Specification
CFast CFast Specification Revision 1.1
Platform Firmware Unified Extensible Firmware Interface (uEFI) specification, version 2.3.1
All Kontron products Product Safety and Implementation Guide, ID 1021-9142