Voice text reply, Electronics, Warning – Jeep 2015 Wrangler - User Guide User Manual

Page 96

While In:

Voice Command Example:

Memo Mode

To switch to the voice recorder mode, say “Memo.”

The following are common voice commands for this mode:

“New Memo” (to record a new memo) — During the record-

ing, you may push the Voice Command button

to stop recording. You proceed by saying one of the

following commands:

— “Save” (to save the memo)

— “Continue” (to continue recording)

— “Delete” (to delete the recording)

— “Play Memos” (to play previously recorded memos) —

During the playback you may push the Voice Command

button

to stop playing memos. You proceed by

saying one of the following commands:

— “Repeat” (to repeat a memo)

— “Next” (to play the next memo)

— “Previous” (to play the previous memo)

— “Delete” (to delete a memo)

— “Delete All” (to delete all memos)

Voice Text Reply

If equipped with Uconnect

Voice Command, your Uconnect

430N/730N radio

may be able to play incoming Short Message Service (SMS) messages (text mes-
sages) through the vehicle's sound system. It also allows you to respond by selecting
from various predefined phrases.

NOTE:
Not all phones are compatible with this feature. Refer to the phone compatibility list
at UconnectPhone.com. Connected mobile phones must be bluetooth-compatible
and paired with your radio.
• Push the “Voice Command” button

and after the BEEP, say “SMS” to get

started.

NOTE:
To access the tutorial, push the “Voice Command” button

. After the BEEP, say

“tutorial.” Push any button on the faceplate or press any button on the touchscreen to
cancel the tutorial.

WARNING!

Any voice commanded system should be used only in safe driving conditions
following applicable laws regarding phone use. Your attention should be focused
on safely operating the vehicle. Failure to do so may result in a collision causing
you and others to be severely injured or killed.

ELECTRONICS