Jeep 2015 Wrangler - User Guide - Manual (Page 19)

LATCH Weight Limit
You may use the LATCH anchorage system until the combined weight of the child and
the child restraint is 65 lbs (29.5 kg). Use the seat belt and tether anchor instead of
the LATCH system once the combined weight is more than 65 lbs (29.5 kg).
Locating LATCH Anchorages
The lower anchorages are round bars that are found at the rear of the seat
cushion where it meets the seatback, below the anchorage symbols on the seatback.
They are just visible when you lean into the rear seat to install the child restraint. You
will easily feel them if you run your finger along the gap between the seatback and
seat cushion.
Locating Tether Anchorages
• In addition, there are tether strap anchors located behind each rear seatback,
near the floor.
Center Seat LATCH (Two-Door Models)
WARNING!
This vehicle does not have a center seating position. Do not use the center lower
LATCH anchorages to install a child seat in the center of the back seat.
Center Seat LATCH (Four-Door Models)
Do not install child restraints with rigid lower attachments in the center seating position.
Only install this type of child restraint in the outboard seating positions. Child restraints
with flexible, webbing mounted lower attachments can be installed in any rear seating
position. In the center position, the inner anchorages are 19 inches (484 mm) apart.
Two Door Vehicle Tether Locations Four Door Vehicle Tether Locations
GETTING STARTED
17