Jeep 2012 Grand Cherokee SRT - User Guide - Manual (Page 32)

Rear Wiper
Wiper Operation
• Rotate the center portion of the lever forward to the first detent for
intermittent operation and to the second detent for rear wiper operation.
Washer Operation
• Rotate the center portion of the lever past the second detent to activate
the rear washer.
High Beam Operation
• Push the lever forward to activate the high beams. Pull the lever toward
you for flash to pass.
NOTE: For safe driving, turn off high beams when oncoming traffic is
present to prevent headlight glare and as a courtesy to other motorists.
AUTO DIMMING MIRRORS
• The rearview and driver side exterior mirror automatically adjusts for
headlight glare from vehicles behind you.
• You can turn the feature on or off by pressing the button at the base of
the rearview mirror. A light next to the button will illuminate to indicate
when the dimming feature is activated.
SPEED CONTROL
• The speed control switches are
located on the steering wheel.
Cruise ON/OFF
• Push the ON/OFF button to
activate the Speed Control.
• CRUISE READY will appear
on the instrument cluster to
indicate the Speed Control is on.
• Push the ON/OFF button a
second time to turn the system
off.
Set
• With the Speed Control on, push and release the SET – button to set a
desired speed.
Accel/Decel
• Once a speed is set, pushing the RES + button once or the SET – button
once will increase or decrease the set speed approximately 1 mph
(2 km/h).
OPERATING YOUR VEHICLE
30